Martin RoboColor III Manual de usuario descargar pdf (Pagina 22)

22 Troubleshooting RoboColor III

No light emission from some or

all RoboColor III heads.

The lamp is on but the color

wheel is on blackout position.

Change color via lighting

controller.

No lamp inserted. Insert lamp.

Malfunctioning lamp. Replace lamp.

No lamp strike due to too low

mains

voltage.

Measure mains voltage and

check against ballast and

transformer tappings. Correct

tappings if necessary.

Head cables not connected to

RoboColor III controller.

Connect cables. Remember to

switch off the RoboColor III

controller first.

The RoboColor III system

appears to be completely dead

(no reset when switching on).

Mains fuse blown. Replace mains fuse.

PCB fuse(s) blown. Replace PCB fuse(s).

Lamp is cutting out

intermittently.

Ambient temperature is too

high.

Reduce room temperature.

Fan speed is reduced due to fan

covered by dirt and dust.

Clean fan.

Incorrect ballast and transformer

tappings.

Measure mains voltage and

check against ballast and

transformer tappings. Correct

tappings if necessary.

Problem Probable cause(s) Suggested remedy

1 2 ... 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios