Martin CX-2 Manual de usuario descargar pdf (Pagina 13)

CX-4 user manual Stand-alone operation 13

TAND

ALONE

OPERATION

The CX-4 may be operated in a random-action stand-alone mode without a

controller. It may be operated as a single unit or in synchronization with other

CX-4s in “master/slave” configuration. Several options are available to modify

operation. These are selected with the DIP-switch and are described on page 14.

Important! The CX-4 transmits a signal on the data link when DIP-switch

pins 2 and 10 are set to ON. To avoid possible damage,

connect no more than 1 transmitting device to the data link.

SINGLE UNIT OPERATION

The fixture enters stand-alone mode with music trigger when power is applied

and no control signal is received for 5 seconds. To operate, simply apply power

and disconnect the data link.

Options for trigger type and speed may be selected as described below under

“Stand-alone settings”. To select stand-alone mode with auto trigger, set DIP-

switch pins 1, 3, 5, 6, 7, 8, 9, and 11 to off; set pins 2 and 10 to on. Pins 4 and 12

may be on or off.

MASTER / SLAVE OPERATION

Multiple CX-4s can be connected together for synchronized “master/slave”

operation in which the slaves mimic the behavior of the master, which may be

any one of the connected fixtures.

To connect units for master / slave operation

1 Connect the output of one CX-4 to the input of the next CX-4.

2 Connect additional CX-4s output to input. Up to 32 may be connected.

3 Terminate the link on both ends by inserting a

female

termination plug (P/N

91613018) into the data

input

of the first fixture and a

male

termination plug

into the data

output

of the last fixture. The female terminator may not be

required if the first fixture is the master.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Sin comentarios

Martin CX-2 Manual de usuario Pagina 13