Martin CX-2 Manual de usuario descargar pdf (Pagina 15)

CX-2 user manual Operation 15

PERATION

FULL DMX OPERATION

For DMX operation, the CX-2 must be connected to a DMX controller as

described under “Data connection” on page 13. DIP-switch pins 1 - 9 must be set

to the DMX address as described on page 10. Pins 10 and 11 must be set to OFF.

DMX CHANNEL DESCRIPTION

See also the DMX protocol on page 21.

Channel 1 controls the light intensity and the strobe rate. It also allows you to

execute a “stand-alone” program with random color and gobo change using

automatic or music trigger.

All effect wheels are reset to their home position when the fixture is powered up;

they can also be reset from the controller by sending a reset command on channel

Channel 2 controls the position of the color wheel. When set to 100 percent, the

wheel moves to random positions using the trigger selected on channel 1.

Channel 3 controls the position of the gobo wheel. When set to 100 percent, the

wheel moves to random positions using the trigger selected on channel 1.

Channel 4 controls the speed of effect wheel rotation, allowing you to vary the

speed on controllers without cross-faders. If your controller has cross-faders, and

you use them, then set channel 4 to the “tracking” speed (0 percent).

1-CHANNEL DMX OPERATION

The CX-2 may be operated in 1-channel mode with the MC-1 or any DMX

controller. For 1-channel operation, connect the controller as described on page

13.

DIP-switch pin 11 must be set to ON.

If using the MC-1, select DMX channel 1. If using a

DMX controller, any channel within the controller’s

range may be assigned.

ìíë ê é èì åç æ ä

ìëìì

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Sin comentarios

Martin CX-2 Manual de usuario Pagina 15