Martin DMX Switch Pack Manual de usuario Pagina 1

516-II DMX to 0-10 V Converteruser manual

10 OperationDMX switch pack operation1 Turn on the converter, controller, and analog devices.2 Toggle devices 1 - 8 on/off by setting channel 1 as sho

11 Specifications SPECIFICATIONSDIMENSIONSLength . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

©1999 Martin Professional A/S, Denmark.All rights reserved. No part of this manual may bereproduced, in any form or by any means, withoutpermission in

3 SafetyThank you for selecting the Martin 516-II DMX to 0-10 V Converter. This deviceconverts the digital input from Martin and DMX protocol controll

4Setup SETUPUnpackingThe 516-II DMX to 0-10 V Converter comes with the following items. Pleasecheck the contents and verify that nothing is missing or

5SetupMARTIN MODE SETUPThe converter automatically switches to Martin mode when used with Martinprotocol controllers. You may wish to swap the polarit

6Setup• Following the cord cap manufacturer’s instructions, connect the yellow and green wire to ground (earth), the brown wire to live, and the blue

7Setupa phase-reversing cable between them. Up to 32 devices may be connectedon a serial link. 5 Terminate the link by inserting a male termination pl

8SetupDIP-SWITCH ADDRESS TABLEFind the address in the table below. Read the settings for pins 1 - 5 to the left andread the settings for pins 6 - 10 a

9 Operation OPERATIONThe 516-II DMX to 0-10 V Converter is ready to operate when• the DMX mode is selected,• the voltage setting (115/230 V) is correc