Martin RoboColor III Especificaciones descargar pdf (Pagina 7)

TAND

ALONE

OPERATION

The RoboColor Pro 400 may be operated in stand-alone mode without a controller.

Music-trigger uses a built in microphone for sound-activated control and auto-

trigger runs at a preset speed using an internal trig source.

1 Use the DIP-switch on the rear panel to select a trigger type. To select music-

trigger, set DIP-switch pins 1, 2, and 10 to ON. To select auto-trigger, set DIP-

switch pins 2 and 10 to ON. Set all other pins to OFF.

2 Switch on the unit to perform the chosen program.

Note: Some programs shown below are for service use only. Do not use them for

light shows.

Program Pin(s) switched ON

Protocol auto-detect (DMX 512 / Martin RS-485)

Stand Alone Auto-trig

Stand Alone Music-trig

Lamp ON (for lamp adjustment)

Mechanical stop (for service use only)

Adjustment (for service use only)

L.E.D. Chase Auto-trig (for service use only)

L.E.D. Chase Music-Trig (for service use only)

All pins switched ON

2, 10

1, 2, 10

8, 10

5, 10

1, 5, 10

4, 10

1, 4, 10

Table 1: Stand-alone program settings

User.fm Page 7 Monday, April 17, 2000 11:22 AM

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Sin comentarios

Martin RoboColor III Especificaciones Pagina 7