Martin RoboColor III Guía de usuario descargar pdf (Pagina 54)

APPENDIX E - Programming the Centrepiece

Lamp On/Off

[shut]

When powering on the Centrepiece, the lamp itself will remain off

until a ’lamp on’ command is sent fro the controller. Press [shut]

once to ignite the lamp. The status of the display then changes to

{On--}, indicating that the lamp is now on. To enable light output the

tilt mirrors must be moved from the default position as described

below.

[shut]

[up]

To switch the lamp back off again, keep the [shut] key pressed and

move the joystick upwards. The of the display changes to {OFF-},

indicating that lamp is now off. Please note that the Centrepiece

uses a cold restrike lamp, meaning that you must wait 5 to 10

minutes before you can power it back on again.

Tilt Mirrors

[up]

Please note that the tilt mirrors are programmed in pairs placed on

opposite sides of the fixture - you cannot program just a single

mirror.

To program a movement start by moving the joystick up. The status

of the display now changes to {tYXX}, where Y is either 1, 2, 3, 4 or

A (A = All), indicating which mirror pair you are controlling, and XX

is a number between 01 and 99 to indicate the position of the

mirror.

[↑]/[↓]

Press [↑]or[↓] to select which mirror set you want to program.

[up]/

[down]

Move the joystick up or down to change the position of the mirrors.

You will see that the status of the display changes accordingly.

[shut]

Press [shut] to quit the tilt movement mode. The status of the

display then changes to {On--}.

Martin 2308 Controller Version 2.1/3.1 Page 55

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 60 61

Sin comentarios

Martin RoboColor III Guía de usuario Pagina 54