Martin MAC 250 ENTOUR Manual de usuario descargar pdf (Pagina 4)

MAC 250 Beam Installation Note 4

7. A set of six beam effect gobos (P/N 62420250) is supplied in the Kit. See Figure 6. To install a beam

effect gobo, remove a color filter from the color wheel by pressing it gently away from its retaining

tabs (A) and lifting it carefully out of the color wheel (B).

8. Filters and gobos have small beads of silicone applied to them to act as cushions. If a bead of

silicone from a color filter has become stuck to the color wheel, remove it and replace it on the color

filter.

9. Insert gobos with the silicone beads facing the color wheel with reference to Figure 7 and to the

illustration on the last page of this guide. Store the original color filters safely for possible future

re-use.

10. We recommend that you install beam effect gobos in the

color/gobo wheel in the positions seen from the front lens

side* shown in Figure 7 in all the fixtures you modify, so that

all MAC 250 Beam fixtures will have identical behavior under

DMX control. A larger copy of this illustration is included on

page 6 of this guide.

*The previous revision of this installation note showed the

color/gobo wheel seen from the lamp side. Figure 7 shows

the wheel seen from the front lens side instead to give a true

picture of the wheel in reality, because the front lens side is

where the color filters/gobos are actually installed. Note that

when viewed from the front lens side, the gobo slots are

numbered counterclockwise.

11. See Figure 8. The new

front lens assembly (P/N

62409076) has a safety

cable with a carabiner

clip. Attach the clip to the

head using either of the

two holes (A) provided in

the new front lens

mounting bracket, then

push the clip flat (B) to

give space for the front

lens assembly.

Figure 6

Figure 7

Figure 8

1 2 3 4 5 6 7 8

Sin comentarios

Martin MAC 250 ENTOUR Manual de usuario Pagina 4