Martin MAC 500 Manual de usuario descargar pdf (Pagina 5)

Troubleshooting 5

Martin University MAC 2000 Service Seminar

ROUGH OR NOISY GOBO OR EFFECT SELECTION

Belt too tight: Adjust tension.

Loose wheel: A noisy wheel probably indicates that the screws connecting the wheel to

the shaft adaptor are loose. Apply Loc-tite and tighten.

ROUGH GOBO OR EFFECT ROTATION

Worn, dirty, or dry bearing: Clean and lubricate the bearing with silicone lubricant.

Replace the bearing if necessary.

GOBOS SLIP IN HOLDER OR FALL OUT

Gobo retaining spring not seated correctly: The narrow end of the gobo retention

spring must be inserted against the gobo. Squeeze the spring flat to see which end is

narrowest. Make sure the wide end of the spring is fully seated under the lip of the holder.

Effect glass must be glued into the holders.

GOBOS DO NOT INDEX CORRECTLY

Worn, dirty, or dry bearing: Clean and lubricate the bearing with silicone lubricant.

Replace the bearing if necessary.

COLOR MIXING

COLOR FLAGS LOSE STEP

Defective motor or motor driver. Check motor, cables, and driver.

CMY MODULE TIMEOUT (CYER, MAER, YEER, CTER)

Improper adjustment of the indexing switch: Adjust the indexing switch so that it is

activated approximately 1 mm before the filter reaches the mechanical stop.

Improper belt mounting: Check that the plastic male clip is fully mated with the plastic

female part of the drive sled.

Loose drive pulley: Tighten drive pulley.

ROUGH MOVEMENT

Improper belt tension: If the drive belt is too tight or too loose, color mixing will be

choppy or difficult.

Slides need lubrication: Apply an extremely light film of recommended Martin High

temperature Silicone oil to the slides. Apply 1 small drop and spread evenly. It is better to

have too little oil than too much.

IRIS

IRIS LOSES STEP OR MOVES ERRATICALLY

Defective motor or motor driver. Check motor, cables, and driver.

NOISY IRIS

Iris noise at fast speed, can be caused from vibrations from the drive motor. Operating the

iris at slower speeds reduces the noise. Replacing the iris is the only other solution.

1 2 3 4 5 6 7

Sin comentarios

Martin MAC 500 Manual de usuario Pagina 5