Martin MAC 101 Series Manual de usuario descargar pdf (Pagina 12)

12 MAC 250 Krypton

where you want some fixtures to mirror the performance of others with the same DMX address, or when

fixtures are not oriented as programmed.

•

PTSP, the pan/tilt speed menu, provides 3 settings: FAST, NORM and SLOW. NORM is best for

most applications.

FAST provides better performance in applications where speed is most important.

•

SCUT, the shortcuts setting which can be found under the PERS (personality) menu, determines whether

the color and gobo wheels scroll past open when changing positions. When set to

ON, the wheels can “take

a shortcut” and scroll through open when this is the shortest path to the next position. The wheels do not

scroll past open when

SCUT is set to OFF.

DISPLAY

The display menu (PERS>dISP) determines whether the display remains lit or not. Select ON to have

the display remain lit, or OFF to extinguish the display two minutes after the last key press.

To flip the display for easier reading, press [up] and [down] simultaneously.

The display intensity setting (

PERS>dINT) controls display brightness. You can select AUTO for

automatic dimming of the display using the built-in light sensor, or manually select an intensity level from 10

to 100.

LAMP POWER

There are two settings that modify lamp control: Automatic Lamp On (PERS>ALON) and DMX Lamp-Off

(

PERS>DLoF).

There are three options for automatic lamp control: ON, OFF, and DMX. When ALON is OFF, the lamp

remains off until a lamp-on command is received from the controller. When

ALON is ON, the lamp strikes

automatically after the fixture is powered on. When

ALON is set to DMX, the lamp strikes automatically

when the fixture receives DMX data, and it extinguishes automatically 15 minutes after DMX data is lost.

When ALON is either ON or DMX, lamp strike timing is determined by the fixture address to prevent all

lamps from striking at once.

The DMX Lamp-Off setting effects how the lamp can be turned off. When

dLOF is ON, lamp power can be

switched off by sending a DMX value from 248 to 255 on channel 1 for five seconds. When

dLOF is OFF,

the lamp-off command will not work unless special conditions are met. Refer to the DMX protocol.

RESET

The fixture can be reset from the controller if DMX reset (PERS>dRES) is set to 5SEC. If DMX reset is

OFF, this command will not work unless special conditions are met. Refer to the DMX protocol.

DEFAULT SETTINGS

The fixture can be reset to its factory default settings by selecting dFSE>FACT>LOAd.

Information readouts

POWER-ON HOURS

Read the total number of hours the fixture has been on since fabrication (INFO>TIME>HRS>TOTL),

and the number of hours on since the counter was last reset (

INFO>TIME>HRS>RSET). This can be

used to track maintenance intervals. Press [up] for 5 seconds while displayed to reset.

LAMP HOURS

Read the total number of lamp hours since fabrication (INFO>TIME>L HR>TOTL), and the number

of lamp hours since the counter was last reset (

INFO>TIME>L HR>RSET). Reset this counter after

installing a new lamp. Press [up] for 5 seconds while displayed to reset.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 38 39

Comentarios a estos manuales

Sin comentarios

Martin MAC 101 Series Manual de usuario Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Controladores de dj Martin MAC 101 Series