Martin MAC 101 Series Manual de usuario descargar pdf (Pagina 13)

Control Panel 13

LAMP STRIKES

Read the total number of lamp strikes (INFO>TIME>L ST>TOTL), and the number of lamps strikes

since the counter was last reset (

INFO>TIME>L ST>RSET). Reset this counter when installing a

new lamp. Press [up] for 5 seconds while displayed to reset.

FIRMWARE VERSION

INFO>VER

displays the firmware version number. The firmware version is also displayed briefly at

startup.

Test and service utilities

DMX READOUT

The DMX log (dMXL) menu provides useful information for troubleshooting control problems.

RATE displays the DMX refresh rate in packets per second. Values lower than 10 or higher than 44 may

result in erratic performance, especially when using tracking control.

qUAL displays the quality of the received DMX data as a percentage of packets received. Values much

below 100 indicate interference, poor connections, or other problems with the serial data link that are the

most common cause of control problems.

STCO displays the DMX start code. Packets with a start code other than 0 may cause irregular

performance.

The remaining options under

dMXL display the DMX values received on each of the 13 channels, from

SHUT (shutter, channel 1) to EFSP (effect speed, channel 13). If the fixture does not behave as expected,

reading the DMX values can help you troubleshoot the problem.

MANUAL CONTROL

The manual control menu (MAN) provides commands for turning the lamp on (LON), turning the lamp off

(

LoFF), and resetting the fixture (RST). It also permits you to position and move individual effects.

EFFECTS TEST

The test sequence (TSEQ>RUN) runs through all effects to provide a quick check of fixture performance.

Note: the test sequence does not automatically strike the lamp. Use

MAN>LON and MAN>LoFF to

control lamp power. Press [menu] to stop the test.

FEEDBACK TOGGLE

Magnetic sensors monitor the positions of the color wheel, gobo wheel, and rotating gobos. If they detect an

error, the shutter closes while the effect resets. This feature can be disabled by turning effects feedback off

(

UTIL>EFFb>OFF).

ADJUSTMENT POSITIONS

The adjustment menu (UTIL>AdJ) provides commands for positioning effects during mechanical

adjustment.

EFFECT CALIBRATION

With the calibration menu (UTIL>CAL), effect positions can be fine-tuned with a software-defined offset

value to compensate for small misalignments or differences between fixtures.

The default offset command (

UTIL>dFOF) erases any offsets stored in memory.

CIRCUIT BOARD TEST

UTIL>PCBT

executes a routine designed for testing the main circuit board. For service use only.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 38 39

Comentarios a estos manuales

Sin comentarios

Martin MAC 101 Series Manual de usuario Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Controladores de dj Martin MAC 101 Series