Martin MAC 300 Manual de usuario descargar pdf (Pagina 5)

Lamp Installation

section 2

LAMP INSTALLATION

This section describes how to install a lamp.

Compatible lamps

The lamps listed in the table below may be used with the MAC 300. Installing any other lamp may damage the fixture.

Installing or changing the lamp

WARNING!

Always disconnect the fixture from AC power and allow it to cool before installing

the lamp.

To protect against lamp explosion, allow a hot lamp to cool for at least

5 minutes before removing the lamp socket.

Remove the 2 Phillips screws from the lamp socket assembly. Pull the lamp and socket out of the head.

Remove the old lamp, if any, from the socket.

3. Holding the new lamp by its ceramic base

(do not touch the glass), align the small pin with

the small hole and insert the lamp squarely into the socket. Make sure that the 4 small projec-

tions on the base contact the face of the socket.

Clean the glass bulb with the cloth supplied with the lamp, particularly if your fingers touched the

glass. A clean, lint-free cloth wetted with alcohol may also be used.

Gently insert the assembly, making sure the lamp fits through the opening in the reflector.

Replace the 2 screws.

Please see “Optimizing reflector alignment” on page 19 to optimize light output.

Lamp

Replace

before Average life Color Temp. Output P/N

Osram HSD 250 2500 hr. 2000 hr. 6000K 68 lm/W 97010103

Philips MSD 250/2 2200 hr. 2000 hr. 6500K 72 lm/W 97010100

Philips MSD 200 2200 hr. 2000 hr. 5600K 67 lm/W 97010106

Figure 1: Lamp installation

reflector alignment screws

lamp socket assembly

1 2 3 4 5 6 7 8 9 10 ... 27 28

Sin comentarios

Martin MAC 300 Manual de usuario Pagina 5