Martin MAC 300 Manual de usuario descargar pdf (Pagina 15)

Control panel operations 15

Battery power

The display and control panel are powered by the MAC III Profile’s onboard battery. This gives access to the

most important functions in the control panel – including DMX addressing – when the fixture is not

connected to AC power.

To activate the display when the fixture is not connected to power, press the Escape button. The display

extinguishes after 10 seconds with no jog wheel activity and the control panel is de-activated after 1 minute

with no jog wheel activity. Press the Escape button again to re-activate.

A battery icon in the display shows battery charging status.

Mains power indicator

A mains plug icon appears in the display when the fixture is connected to AC mains power.

Status indicators in display

The status indicators on the right of the display have the following functions:

• LAMP lights when the lamp is powered.

• ETHERNET lights when the MAC III Profile is correctly connected to an Ethernet network.

• DMX lights when the MAC III Profile is receiving a valid DMX signal.

• PAN/TILT lights when pan/tilt limits have been activated (see page 16).

Shortcuts pop-up

If you hold the Escape button pressed in for 2 - 3 seconds, a pop-up window with

shortcuts to 3 important commands appears. Select a command and click the jog

wheel to activate, or press Escape to cancel.

• RESET resets the whole fixture

• LAMP ON/OFF strikes or douses the lamp.

• ROTATE DISPLAY rotates the MAC III Profile display.

Settings stored permanently

The following settings are stored permanently in the fixture memory and are not affected by powering the

MAC III Profile off and on or by updating the fixture software:

• DMX address

• DMX Protocol setting

• Fixture ID

• All personality settings (pan/tilt and pan/tilt limit, linked zoom/focus, lamp cooling, fan clean mode,

dimming curve, DMX lamp off, DMX reset, parameter shortcuts, all display settings, error mode)

• Factory settings

• Fixture info (resettable power-on, lamp-on, lamp strikes, and air filter counters)

• All Service settings (adjust, calibration, firmware)

These settings can be returned to factory defaults using the control menus or via DMX.

DMX address

The DMX address, also known as the start channel, is the first channel used to receive instructions from the

controller. For independent control, each fixture must be assigned its own control channels. If you give two

MAC III Profiles the same address, they will behave identically. Address sharing can be useful for diagnostic

purposes and symmetrical control, particularly when combined with the inverse pan and tilt options.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 55 56

Sin comentarios

Martin MAC 300 Manual de usuario Pagina 15