
Operation
13
current to trip circuit breakers. If sending “lamp on” commands to multiple fixtures, program a sequence that strikes
lamps one at a time at 5 second intervals.
The fixture automatically strikes the lamp within 90 seconds of being powered on if the Automatic Lamp On setting
(
PERS/ALON) is turned on. A delay determined by the fixture address staggers lamp strikes to prevent excessive
voltage drop and current draw.
The lamp can be turned off from the controller. Note: the lamp cannot be restruck for 8 minutes after being turned off.
Accidental “lamp off” commands can be prevented by turning the DMX Lamp Off setting (
PERS/dLOF) off.
Color
The MAC 250 and MAC 250
+
color wheel provides a 5500 to 2900K color temperature correction (CTC) filter and 11
dichroic color filters. The wheel can be scrolled continuously - allowing for split color effects - or in steps, and rotated
randomly or continuously in both directions at different speeds.
The Shortcuts setting (
PERS/SCUT) determines whether or not the wheel takes the shortest path to the next posi-
tion; this setting may be overridden on the speed channel in vector mode. Setting the effects speed to “blackout” causes
the shutter to black out the light while the wheel is moving.
The color filters on the MAC 250
+
are interchangeable. See page 16.
Rotating gobos
The MAC 250 and MAC 250
+
has 8 rotating gobo positions plus an open position. Each gobo rotates and/or “shakes” at
varying speeds. Gobos and shake are selected on channel 4; rotation is set on channel 5. The gobo wheel also rotates
continuously in both directions at variable speed.
.
Position Color
1CTC
2 Yellow 603
3 Blue 104
4 Pink 312
5 Green 206
6 Blue 108
7 Red 301
8 Magenta 507
9 Blue 101
10 Orange 306
11 Green 202
12 Purple 502
Table 4: Color positions
MAC
250
+
color wheel shown
.
Position Gobo
1 Radial Dashes
2 Line of Beams
3 Fan Hat
4 Triple Beam
5 Decentered Beam
6 Fibroid
7 Random Holes, Blue
8 Psycho Circles, Magenta
Table 5: Gobo positions
Comentarios a estos manuales