Martin MAC 250+ Manual de usuario descargar pdf (Pagina 24)

Appendixes

Error messages

Display readout Appears if... What to do

AUTO (Automatic protocol detec-

tion error)

Automatic protocol detection is enabled

and there is no control input.

• Verify that controller is connected

properly and sending data.

LERR (Lamp error) ... the lamp doesn’t ignite within 10 min-

utes of receiving the ‘Lamp ON’ com-

mand.

• Check the lamp

• Check voltage and frequency settings

MERR (Memory error) ...the EEPROM memory cannot be

read.

• Contact service technician.

CSER (Check-sum error) ...a software upload is unsuccessful. • Reload software, see page 20.

**** ... there is no communication between

the control panel and motherboard.

This appears briefly when switching on

the fixture.

• Check fuses.

• Check cable between control panel

and motherboard.

• Reinstall software.

• Contact service technician.

ShER (Short error) ... the fixture detects the lamp is ON but

no ‘Lamp ON’ command has been

received. This can occur if the lamp

relay is stuck.

• The fixture may be operated but

remote lamp on/off may be effected.

• Contact service technician.

Hot (Hot lamp) ... you attempt to strike the lamp within

8 minutes after having switched it off.

The fixture will store the ‘Lamp ON’

instruction and strike the lamp once the

8 minutes period has elapsed.

• Wait until the lamp strikes.

FbEP (Feedback error pan)

FbET (Feedback error tilt)

FbER (Feedback error pan/tilt)

...pan (FbEp), tilt (FbET) or both (FbER)

feedback circuits are malfunctioning.

• The fixture will still operate, though

with reduced maximum speed to pre-

vent the fixture from losing track of its

position.

• Contact service technician.

PAER (Pan time-out)

TIER (Tilt time-out)

...the pan or tilt indexing circuit is mal-

functioning.

• After the time-out the fixture will work

normally.

• Contact service technician.

COER (Color wheel time-out)

RgER (Rot. gobo time-out)

...the magnetic-indexing circuit malfunc-

tions (e.g. sensor defective or magnet

missing).

• After the time-out, the effect in ques-

tion stops in a random position.

• Contact service technician.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30

Comentarios a estos manuales

Sin comentarios

Martin MAC 250+ Manual de usuario Pagina 24

Comentarios a estos manuales

Relacionado con productos y manuales para Controladores de dj Martin MAC 250+