Martin RoboColor III Manual de usuario descargar pdf (Pagina 12)

12 Service and Maintenance RoboColor III

ERVICE

AND

AINTENANCE

GENERAL MAINTENANCE

Warning! Disconnect the system from AC power before removing any

cover.

To ensure optimum performance from the RoboColor III system, it is important to

keep the heads clean. Dirty lenses and filters reduce the brightness and diffuse the

beam. A fan blocked by dust may provoke overheating and cause the thermostat

to cut out the lamp intermittently. Thanks to the mechanical construction of the

RoboColor III, maintenance and cleaning can be done easily and requires no

special tools.

The RoboColor III controller should not require any maintenance.

Clean the optics

1 To access the optical components

inside head, remove the screws as

shown and then lift and remove

the bottom cover.

2 Use only a clean, soft and lint-free

cloth to clean the color filters. You

may need to wet the cloth in a non-

aggressive glass cleaning liquid if

the filters are greasy. Use the

same cloth to clean the focus

objective.

Clean the cooling fan

• For adequate cooling of the

head, the fan must be free of

dust. Clean the fan if the air

flow seams to be reduced.

The fan is located at the top of

the unit as per the following

figure. It is easiest to clean

the fan using compressed air.

Remove the 4 screws.

Then lift and remove the cover.

Use compressed air

to clean the fan.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Sin comentarios

Martin RoboColor III Manual de usuario Pagina 12