Martin RoboColor III Manual de usuario descargar pdf (Pagina 16)

16 Service and Maintenance RoboColor III

2 On the ballast, move the BLACK wire to the correct voltage terminal. Use the

following table to select the correct voltage setting.

3 Re-assemble the unit.

FUSES

Should the RoboColor III system cease to work it may be due to a blown fuse.

This section describes how to replace the fuses.

To replace the primary fuse

• The primary fuse is located inside the IEC mains input socket at the rear of

the controller. Use a small screwdriver to pry open the fuse holder and

replace the fuse with one of the same size and rating. The fuse rating is also

printed on the serial number label.

50 Hz Model 60 Hz Model

Mains supply Ballast tapping Mains supply Ballast tapping

210V - 235V 230V 200V - 215V 210V

235V - 245V 240V 215V - 225V 220V

245V - 255V 250V 225V - 235V 230V

Ballast

210V/60Hz

230V/60Hz

220V/60Hz

Ballast

230V/50Hz

250V/50Hz

240V/50Hz

50 Hz Version

60 Hz Version

IEC mains input

socket.

Mains fuse

6.3AT/250V (slow

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Martin RoboColor III Manual de usuario Pagina 16