Martin RoboColor III Manual de usuario descargar pdf (Pagina 7)

User Manual Setting Up 7

2 Connect the data output of the first

RoboColor III controller

to the data input

of the next device. Use the XLR-XLR cable supplied when connecting to

another RoboColor III controller or fixture with Martin polarity (pin 3 cold).

Use a phase-reversing cable when connecting to a DMX device (pin 3 hot).

3 Continue the link this way, connecting output to input (daisy-chaining), until

all units are linked together.

4 Finally, insert a male XLR termination plug in the output socket of the last

unit on the link. Use a 3 pin XLR male plug with a 120

Ω

ΩΩ

Ω

resistor between pin 2

and 3 (supplied with all Martin controllers).

Important! Failure to use a termination plug can cause communication errors

between the lighting controller and the units.

Phase-Reversing

Cable

Male Female

3-pin to 3-pin

Connections

P/N 11820006

Phase-Reversing

Cable

Male Female

3-pin to 5-pin

Connections

P/N 11820002

Phase-Reversing

Cable

Male Female

5-pin to 3-pin

Connections

P/N 11820003

Lighting controller

RoboColor III controllers

Insert a termination

plug in the last unit

on the data link.

Use 3 pin XLR/XLR data cables to connect

the units. Pin 1 = screen, pin 2 = signal (+),

pin 3 = signal (-).

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comentarios a estos manuales

Sin comentarios

Martin RoboColor III Manual de usuario Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Reflectores Martin RoboColor III