Martin RoboColor III Manual de usuario descargar pdf (Pagina 8)

8 Setting Up RoboColor III

ADDRESSING THE SYSTEM

When using the RoboColor III with a lighting controller, you must set the DIP-

switch to the start channel, also known as the address, which is the first channel

the controller uses to send instructions to the RoboColor III system.

For independent control, each RoboColor III system must have its own address

and non-overlapping control channels. If two or more RoboColor III systems have

the same address they will receive the same instructions and behave identically.

Martin mode

: The RoboColor III uses 1 channel to communicate with the

controller. The address may be any channel between 1 and 32.

DMX mode

: The RoboColor III uses 5 consecutive DMX channels in tracking

mode (DMX mode 1) and 6 consecutive DMX channels in vector mode (DMX

mode 2).

The factory default is DMX mode 1.

Example: 4 RoboColor III systems using DMX mode 1 may be addressed as

follows:

Set a Martin address

1 Select an available address from 1 to 32.

2 Look up the DIP-switch setting on page 9.

3 Set the DIP-switch by flipping ON the pins found in step 2.

4 Set DIP-switch pins 7 - 10 to OFF.

Set a DMX address

1 Select an available address from 1 to 507 within the lighting controller’s

range.

2 Look up the DIP-switch setting on page 9.

3 Set the DIP-switch by flipping ON the pins found in step 2.

4 Set DIP-switch 10 to OFF.

System 1

Address: 1

System 2

Address: 6

System 3

Address: 11

System 4

Address: 16

DMX Mode Color Control DMX Channels PL113 Jumper Setting

1 default Tracking 5 Channels No Jumper

2 Tracking/Vector 6 Channels Pin 1 and 2

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Sin comentarios

Martin RoboColor III Manual de usuario Pagina 8