Martin MAC 250 ENTOUR Manual de usuario descargar pdf (Pagina 8)

8 MAC 250 Krypton/Entour

CONFIGURING FOR LOCAL AC POWER

1 Disconnect the fixture from power.

2 Remove the 2 Phillips screws in the access cover directly behind the power and data connectors. Lift off the

cover.

3 Locate the selection switches.

4 Move the voltage switch to the setting that most closely matches the local AC voltage. If your voltage falls

halfway between 2 settings, select the higher voltage. For example, if the AC voltage is 220 V, use the 230

V setting instead of 210 V.

5 Move the frequency switch to the setting that matches the local AC frequency: 50 or 60 Hz.

6 Replace the cover.

INSTALLING A PLUG ON THE POWER CABLE

The power cable must be fitted with a grounding-type cord cap that fits your power distribution system.

Consult an electrician if you have any doubts about proper installation.

• Following the cord cap manufacturer’s instructions, connect the yellow and green wire to ground (earth), the

brown wire to live, and the blue wire to neutral. The table below shows some pin identification schemes.

APPLYING POWER

Warning! The power cables must be undamaged and rated for the electrical requirements of all

connected devices.

Important! Powering through a dimmer system can damage the fixture.

1 Verify that the supply cable is undamaged and rated for the current requirements of all connected devices.

2 Plug the prepared power cable into the AC socket and a grounded AC power supply.

Wire Pin Marking Screw color

brown live “L” yellow or brass

blue neutral “N” silver

yellow/green ground green

Table 1: Plug wiring

120

100

210

230

250

Figure 1: Power supply settings

Voltage

Frequency

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 48 49

Sin comentarios

Martin MAC 250 ENTOUR Manual de usuario Pagina 8