Martin MAC 700 PROFILE Manual de usuario descargar pdf (Pagina 13)

Control panel 13

DIMMER

The dimmer curve setting (→) provides two options for dimmer behavior. Select for a

near-linear dimming curve or to simulate tungsten lamp dimming characteristics.

DISPLAY

The display intensity (→) setting controls display brightness. Select  for automatic

display or manually set the intensity to a level from

 to .

The display on/off setting (

→) determines whether the display remains on (), remains on

for 2 minutes after the last key press (), or for 10 minutes after the last key press ().

To flip the display, press [Up] and [Down] simultaneously.

LAMP

There are two settings that modify lamp control: Automatic Lamp On (→) and DMX Lamp Off

(

→).

When

 is , the lamp remains off until a “lamp on” command is received. When  is , the

lamp strikes automatically after the fixture is powered on. When

 is set to , the lamp strikes

automatically when the fixture receives DMX data, and it douses 15 minutes after DMX data is lost.

When

 is set to either  or , the automatic lamp strike timing is staggered to prevent all lamps

from striking at once. The delay is determined by the fixture address.

The DMX Lamp Off (

) setting allows you to enable () or disable () the DMX command that

switches off the lamp. The special combination of DMX values listed on page 23 allows you to execute the

lamp-off command even when disabled.

DMX RESET

The DMX reset (→) setting controls the behavior of the reset command. When set to , the

command is fully enabled. When set to

, the command is disabled to prevent accidental resets. When

set to , the command must be sent for five seconds. The special combination of DMX values listed on

page 23 allows you to execute a reset even when the command is disabled.

CMY BLACKOUT

The CMY blackout (→) setting enhances blackout effectiveness. When set to , the CMY

flags deploy 3 seconds after dimmer blackout. These absorb any light that may escape past the dimmer.

The CMY flags take a fraction of a second longer to open than the dimmer blades, however, so setting CMY

blackout to

 (the default setting) allows the fixture to snap open more rapidly after a blackout.

CUSTOM SETTINGS

The custom configuration function → - allows you to save and recall three sets of

fixture settings. The savable settings are DMX mode, pan/tilt speed, pan/tilt inverse and swap, DMX lamp

off and reset, display settings, shortcuts, studio mode, automatic lamp on, effects feedback, tracking

algorithm, and tracking samples.

Readouts

TIME

→ provides readouts of fixture hours (), lamp hours (), and lamp strikes ().

Under each item is a resettable () increment counter and a non-resettable () counter for total

accumulated hours/strikes since fabrication. To reset an increment counter, display it and then press [Up]

until it reads

.

TEMPERATURE

→ provides temperature readouts for the lamp, PCB and power supply unit in Celsius and

Fahrenheit.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Comentarios a estos manuales

Sin comentarios

Martin MAC 700 PROFILE Manual de usuario Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Controladores de dj Martin MAC 700 PROFILE