Martin MAC 700 PROFILE Manual de usuario descargar pdf (Pagina 9)

Lamp 9

5. With the nipple on the replacement lamp facing towards the back as shown in Figure 3, insert the left pin

into the socket. Push down on the right-hand spring and snap the pin into place.

6. See Figure 4. Make sure that the terminals on the

lamp sit below the V-section in the lampholder clips

and not in the V-section itself.

7. Lift the lamp assembly so that lamp is level with the

center of the reflector. Push the assembly straight in

until it seats, making sure the lamp passes through

the reflector opening.

8. Push and turn the 4 fasteners a quarter turn or so

clockwise to close the lamp access panel.

9. After installing a new lamp, reset the lamp hour and

lamp strike counters. See “Time” on page 13.

To align the lamp

Important! Align the lamp carefully. An excessive hot-spot

will damage optical components.

1. Apply power and allow the MAC 700 Wash to reset.

Using either a controller or the control menu, strike the

lamp and project an open white beam on a flat surface.

2. See Figure 5. Center the hot spot vertically using the

top Allen-head adjustment screw (A) in the center of the

rear plate. Center the hot spot horizontally using the

side-to-side adjustment screws (C).

3. If there is an excessive hot spot, turn the bottom

adjustment screw (B) counterclockwise until the light is

evenly distributed. If the light is brighter around the

edge than it is in the center, or if light output is low, turn

the bottom adjustment screw (B) clockwise until the

light is bright and evenly distributed.

Figure 3: Lamp insertion

Nipple facing towards back

Figure 4: Lamp terminals

Figure 5: Lamp adjustment screws

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Sin comentarios

Martin MAC 700 PROFILE Manual de usuario Pagina 9