Martin MAC 700 PROFILE Manual de usuario descargar pdf (Pagina 14)

14 MAC 700 Wash

FIRMWARE VERSION

→ displays the version number of the installed firmware. The firmware version is also displayed

briefly at startup.

DMX

The DMX log () menu provides useful information for troubleshooting control problems.

 displays the DMX refresh rate in packets per second. Values lower than 10 or higher than 44 may

result in erratic performance, especially when using tracking control.

 displays the quality of the received DMX data as a percentage of packets received. Values much

below 100 indicate interference, poor connections, or other problems with the serial data link that are the

most common cause of control problems.

 displays the DMX start code. Packets with a start code other than 0 may cause irregular

performance.

The remaining options under

 display the DMX values received on each channel. If the fixture does

not behave as expected, reading the DMX values can help you troubleshoot the problem.

Service messages

The Service LED on the control panel lights under conditions that require fixture service, and there is a

message describing the service required. To display the message, select  in the main menu. This

item is available only when the LED is lit. There are two service messages.

 is displayed when the lamp counter exceeds 750 hours, which is the rated average life

for the lamp.

is displayed when the head temperature exceeds 85° C (185° F).

Overheating is probably due to dirty air filters, fans, or air vents; incorrect power supply settings, or a

defective fan.

Manual control

The manual control menu () provides commands for resetting the fixture (), striking the lamp

(

), and dousing the lamp (). It also permits you to position and move individual effects.

Service utilities

Important! [Enter] must be held for several seconds to access the utilities menu.

TEST SEQUENCES

 provides a general test of all effects that can be run without a controller. → provides

routines for circuit board testing that are for service use only.

FEEDBACK TOGGLES

An on-the-fly position correction system monitors the color wheel. If a position error is detected, the shutter

closes while the color wheel resets. This feature can be disabled by turning effects feedback

(

→) off. The off setting is not saved and the system will be re-enabled the next time the fixture

starts.

The automatic pan/tilt position correction system may be temporarily turned off under

→. The

off setting is not saved and the system will be re-enabled the next time the fixture starts. If the system

cannot correct the pan/tilt position within 10 seconds, feedback is automatically disabled.

ADJUSTMENT

The adjustment menu (→) provides manual control for making mechanical adjustments. See

page 29.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Comentarios a estos manuales

Sin comentarios

Martin MAC 700 PROFILE Manual de usuario Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Controladores de dj Martin MAC 700 PROFILE