Martin MiniMAC Maestro Manual de usuario descargar pdf (Pagina 26)

26 General operation

General operation

When the Exterior 600 is connected to power it will reset.

Lamp operation

Avoid turning on several lamps at once.

To optimize lamp life, always allow the lamp to warm up fully before turning

it off.

For optimum lamp life, turn off lamp power whenever illumination is not

required for extended periods of an hour or more. Fixture power may remain

on when not in use.

After being turned off, the lamp must cool for at least 8 minutes before it can

be turned back on. “Lamp on” commands sent within 8 minutes of a “lamp

off” command are stored and then attempted again after the time has

elapsed.

Cold weather operation

When the temperature is expected to fall below freezing, leave the fixture

powered on when not in use to keep the electronics warm. The lamp,

however, may be switched off.

Front glass care

Masking or covering the front glass in the Exterior 600 will cause undue heat

buildup, and this may result in damage that is not covered by the product

warranty.

The front glass may crack if the center is masked or covered over (for

example, with sand or sticky tape). Keep the front glass clear of

accumulated sand, dust, leaves, bird droppings, etc. at all times. Take

particular care if construction work is being carried out near the fixtures, or if

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 83 84

Sin comentarios

Martin MiniMAC Maestro Manual de usuario Pagina 26