Martin MiniMAC Maestro Manual de usuario descargar pdf (Pagina 40)

40 Programming from a PC using MUM

When the program is run, scenes execute in a continuous, ascending loop.

Note that, if a “slave” fixture has:

• Fewer scenes than the master fixture, it will run these in a cycle

continuously, until the master fixture signals that the program should start

from the beginning again.

• More scenes than the master fixture, then the additional scenes will never

run, because the program will reset to the first scene when the master starts

its program from the beginning.

Programming the same stand-alone

show on multiple fixtures

Although you can only connect to and program a single fixture at a time

using the MUM, you can use it to program a single fixture, download and

save the fixture settings to a file on your PC, and then upload the stand-

alone program and fixture settings to each subsequent fixture that you

connect to. This is useful if you have a group of fixtures of the same type

that will run the same stand-alone show.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 83 84

Sin comentarios

Martin MiniMAC Maestro Manual de usuario Pagina 40