Martin MAC 250+ Manual de usuario descargar pdf (Pagina 14)

14 MAC 250 Wash

 displays the DMX start code. Packets with a start code other than 0 may cause irregular

performance.

The remaining readouts under

 display the DMX values received on each of the 13 channels

available in both 16-bit and 16-bit Extended modes, from

 (shutter, channel 1) to  (effect

speed, channel 13). If the fixture does not behave as expected, reading the DMX values can help you

troubleshoot the problem.

MANUAL CONTROL

The manual control menu () provides commands for resetting the fixture (), as well as striking the

lamp (

), and dousing the lamp (). It also permits you to position and move individual effects.

EFFECTS TEST

The test sequence (→) runs through all effects to provide a quick check of fixture performance.

Press [Menu] to stop the test.

FEEDBACK TOGGLE

Note that [Enter] must be pressed for 3 seconds to access settings in the  menu.

Sensors monitor the positions of the pan/tilt systems and color wheel. If they detect an error, the effect

resets on the fly. The shutter closes during resetting.

To ease service, for example, this feature can be disabled for pan/tilt by turning pan/tilt feedback off

(

→→). The disabled pan/tilt feedback setting is saved when you exit the →

menu.

Color wheel feedback can also be turned off (

→→). This setting is also saved when you

exit the

→ menu.

ADJUSTMENT POSITIONS

The adjustment menu (→) provides commands for positioning the head and effects, as well as

an effects position test sequence, during service and mechanical adjustment (see “Adjustment submenu”

on page 31).

If the test sequence is run by selecting

→→→ and an error is detected, the test

aborts and a number flashes in the display to indicate which effect is out of position. Note this number and

contact your Martin service center for advice.

EFFECT CALIBRATION

With the calibration menu (→), effect positions can be fine-tuned with a software-defined offset

value to compensate for small misalignments or differences between fixtures.

The default offset command (

→) erases any offsets stored in memory.

CIRCUIT BOARD TEST

→ executes a routine designed for testing the main circuit board. This function is for service

use only.

FAN CONTROL

In →, the cooling fans can be set to run at full speed or set to thermostatically regulated

control. Running at full speed will give maximum lamp and component service life. Running at regulated

speed gives quietest operation.

UPLOAD MODE

The upload mode command (→) prepares the fixture for a software update.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Comentarios a estos manuales

Sin comentarios

Martin MAC 250+ Manual de usuario Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Controladores de dj Martin MAC 250+