Martin MiniMAC Maestro Manual de usuario descargar pdf (Pagina 19)

Control panel

PERSONALITIES

The following settings are available to modify fixture behavior.

Pan/tilt swap: Map pan to the tilt channel and tilt to the pan channel to provide

more intuitive control of fixtures mounted sideways.

Inverse pan: Flip pan movement to right-to-left instead of left-to-right.

Inverse tilt: Flip tilt movement to down-to-up instead of up-to-down.

Pan/tilt speed: Optimize motor control for speed or smoothness.

DMX lamp-off: Disable the lamp-off command unless image 4 is selected and

focus is set to closest (100 percent).

DMX reset: Disable the reset command unless image 4 is selected and focus is set

to closest (100 percent).

Automatic lamp-on: Strike lamps automatically within 90 seconds of applying

power to the fixture. Timing is staggered to prevent excessive current draw.

Display: Turn off the display 2 minutes after the last key press or leave it on. This

setting will be overridden by error messages.

Gobo blackout: Blackout the light automatically - by closing shutter - to make

gobo changes invisible.

Store remote status: When active, this option links the Run/Stop action on the IR

remote to the execution settings for stand-alone operation. When you select run or

stop via the remote control this will update the fixture’s execution settings. This

enables you to – via the IR remote - switch on or off the automatic starting of stand-

alone operation when the fixture is powered on.

Errors message toggle:This enables error messages to be switched on or off. This

enables, for example, the continued programming of a fixture that has a non-critical

error. The default setting is On, which means that errors messages will always be

displayed.

To select a personality setting

•Scroll to PEr in the main menu, press [enter], scroll to the desired personality, and

press [enter]. Select the desired option and press [enter]. Refer to Table 2.

To restore default personality settings

•Scroll to PEr in the main menu, press [enter], and scroll to FAC. Press [enter]

twice to confirm and execute the command.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 50 51

Sin comentarios

Martin MiniMAC Maestro Manual de usuario Pagina 19