Martin MiniMAC Maestro Manual de usuario descargar pdf (Pagina 43)

Basic service

To clean the fan and air vents

Important! Neglecting to clean the fans and air vents can result in damage

to the fixture that is not covered by the warranty. Dust, smoke,

and grease buildup reduce the cooling air flow and will cause

the fixture to overheat. When the fixture overheats, a thermo

switch cuts power to the lamp until the fixture cools, and the

lamp cycles on and off at regular intervals.

To maintain sufficient cooling and air flow, inspect the air vents and fans at least

every 3 months or 1000 hours of operation and clean the fan and air vents by

removing dust and dirt from the fans and vent grills using a soft brush, cotton swab,

vacuum, or compressed air.

INSTALLING SOFTWARE

Firmware updates are released when features are added. The latest version is

available from the Support Area of the Martin Professional web site at

http://www.martin.dk. Firmware is installed using a Martin MP-2 uploader.

Important! Fixtures must be in a DMX mode and the data link must be

terminated.

To install software, normal method

1 Download the latest control software from the Martin Professional web site at

http://www.martin.dk. Install the software in a Martin MP-2 uploader.

2 Connect the uploader to the fixture as you would a controller. Apply power to the

uploader and the fixtures.

3 After the fixture has finished resetting, initiate the software upload as described in the

uploader manual. Wait.

4 When the upload is successfully completed, the fixture displays the new version

number and resets. Disconnect the upload device.

5 If a check-sum error (

CSE) occurs and/or the fixture does not reset, data was

interrupted or corrupted during transmission. Reattempt the upload using backup

method I, or try this procedure again.

To install software, backup method I

Follow this procedure exactly as described to install software if a normal upload

attempt is unsuccessful and a check-sum error (

CSE) occurs.

1 Disconnect the fixture from power: it must be off at least 10 seconds. Do not apply

power to the fixture until the uploader is connected and ready.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 49 50 51

Sin comentarios

Martin MiniMAC Maestro Manual de usuario Pagina 43