Martin MiniMAC Maestro Manual de usuario descargar pdf (Pagina 24)

Controller operation

The speed channel must be set to “tracking speed” when using a cross-fader

(tracking control) to program fades.

The speed channels also provide a “blackout speed” that makes transitions invisible.

8-BIT VERSUS 16-BIT PAN/TILT RESOLUTION

The 8-bit modes (1 and 3) provides coarser control of pan, tilt, and gobo indexing

than the 16-bit modes (2 and 4), which use 3 additional control channels for fine

position control.

To select DMX mode

1Scroll to Pro in the main menu, press [enter], and scroll to the desired DMX mode,

d1, d2, d3, or d4.

2 Press [enter] to activate the setting and return to the main menu.

ADDRESS SELECTION

The control address, also known as the start channel, is the first channel used to

receive instructions from the controller. The total number of channels used depends

on the control mode.

Be sure to allow adequate channels when setting the control address. If control

channels for one fixture overlap control channels for another fixture, then one of the

fixtures will receive the wrong commands. Two MiniMAC Maestros operating in

the same control mode may share the same address if they are to respond

identically. They will receive the same commands and individual control will be

impossible.

To set the control address

1Scroll to Adr in the main menu and press [enter]. The current address is displayed.

2 Scroll to the address that is assigned to the fixture on the controller. Press [enter] to

activate the address setting.

CONTROLLABLE EFFECTS

LAMP POWER

Lamp power can be switched on and off from the controller. When set-up for

controller operation, and with the automatic lamp-on personality set to off, the

lamp remains off until a lamp-on command is sent.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 50 51

Sin comentarios

Martin MiniMAC Maestro Manual de usuario Pagina 24