Martin MiniMAC Maestro Manual de usuario Pagina 46

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 51
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 45
46
Troubleshooting
T
ROUBLESHOOTING
10
Problem Probable cause(s) Remedy
No response from fixture when
power is applied.
No power to fixture. Check power cables.
Primary fuse blown. Replace fuse.
Secondary fuse blown. Replace fuse.
No response to IR remote
control.
Remote control not pointed at
receiver or signal is blocked.
Point remote directly at
receiver from an unobstructed
position.
Backwards IR receiver. Flip and turn receiver arm.
No signal from remote. Replace batteries in remote.
Commands ignored during
execution.
Stop scene execution.
Fixture connected to a data
link that is using a DMX
protocol. This jams the IR
signal.
Remove the fixture from the
link.
Improper setup.
Verify protocol (rCr or rCS)
and address settings.
Fixture resets but does not
respond correctly to controller
(DMX mode operation).
Controller not connected. Connect controller.
Incorrect addressing of the
fixtures.
Check address and mode
settings on fixture and
controller.
Controller pin-out does not
match fixture pin-out (signal
reversed).
Insert a swapper cable in data
input.
Stand-alone mode enabled.
Verify that DMX address is
displayed at top of menu. If
not, disable stand-alone
mode.
Bad data link connection.
Inspect cables and correct
poor connections and/or
broken cables.
Data link not terminated.
Insert termination plug in
output of last fixture.
Defective fixture or 2 devices
transmitting on link.
Bypass fixtures one at a time
until normal operation is
regained: unplug both
connectors and connect them
directly together.
Fixture does not reset. An effect requires adjustment.
Try again. If problem persists,
contact service technician.
Vista de pagina 45
1 2 ... 41 42 43 44 45 46 47 48 49 50 51

Comentarios a estos manuales

Sin comentarios