Martin MiniMAC Maestro Manual de usuario descargar pdf (Pagina 32)

Stand-alone operation

EXECUTION COMMANDS

Important! The execution setting automatically resumes on startup.

Off (

run/OFF): Stop stand-alone execution.

Run single fixture (run/Sin): Start stand-alone operation of a single fixture.

Run master fixture (run/Snd): Select the master fixture and start stand-alone

operation.

Run synchronized fixture (

run/SYn): Select a non-master (synchronized)

fixture and start stand-alone operation.

MC-X EXECUTION

To execute stand-alone scenes with an MC-X Controller

1 Connect the MC-X controller to the MiniMAC Maestro’s data input. If multiple

MiniMAC Maestros are connected, plug the controller into the first fixture in the link.

2 On each fixture, select

Ctr / run / OFF and press [enter]. Press [menu] to exit

the

Ctr menu. Set each fixture to DMX mode 4.

3 To trigger scenes 00-06, press the numbered preset buttons on the MC-X.

4 To have each fixture run its own routine, press [Auto].

REMOTE CONTROL COMMANDS

Important! Fixtures blink to acknowledge commands from the remote

control.

FIXTURE SELECTION

Each fixture must be assigned an address from 0 - 9 during setup so that it can be

individually controlled with the remote control. To select a fixture, press ID and

enter its address using the number keys. Multiple fixtures may be selected by

entering more than one address. For example, pressing [ID] [1] [2] [3] selects

fixtures 1, 2, and 3.

LAMP POWER

The lamp power button toggles lamp power on and off on selected fixtures. The

button must be held for 5 seconds to turn lamp power off. Note: Lamps cannot be

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 50 51

Sin comentarios

Martin MiniMAC Maestro Manual de usuario Pagina 32