Martin MiniMAC Maestro Manual de usuario descargar pdf (Pagina 30)

Stand-alone operation

synchronizes its scenes with the Master, and also note that scene S4 that is

programmed in the Slave fixture will not run.

• The scene times in the Master fixture should be equal to or longer than the

corresponding scene times of the other fixtures. You may get undesirable results if,

for example, a scene is programmed in the master to last 10 seconds and in other

fixtures to fade for 15 seconds. Note that in the following example the scenes in the

Slave run out of their programmed sequence because scenes 0 and 2 on the Slave

are longer than the corresponding scenes on the Master.

MENU COMMANDS

The menu commands can be used to program and execute scenes in both DMX

Stand-Alone Mode and IR Remote Control Mode.

Note Control panel actions sometimes result in a information being

written to the fixture’s memory. If the fixture is powered off

during this process updates may be lost. A “Memory not yet

stored” warning indicator appear as a red dot in the left side of

the control panel display during memory update. Do not power

the fixture off while this is lit.

SCENE COMMANDS

Store scene (SCE/Sto): Save settings in the current scene.

F=fade, W=wait Timeline =>

M0 M1 M2 M3

Programmed in Master F W F W F W F W

S0 S1 S2 S3 S4

Programmed in Slave F W F W F W F W F W

Result M0 M1 M2 M3

FW FWF WFW

S0 S1 S2 S3

FW FW FW ----F W

M=master, S=slave

F=fade, W=wait Time >

Programmed M0 M1 M2

Master F W F W F W

S0 S1 S2

Slave F W F W F W

Result M0 M1 M2 M0 M1

Master F W F W F W F W F W

S0 S2 S1

Slave F W F W .. .. FW .. ..

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 50 51

Sin comentarios

Martin MiniMAC Maestro Manual de usuario Pagina 30