Martin MiniMAC Maestro Manual de usuario descargar pdf (Pagina 44)

2 Connect the MP-2 uploader to the fixture as you would a controller. Terminate

the link.

3 Prepare the uploader for a boot mode upload but do not initiate the upload.

4 Apply power to the fixture. The control panel displays

CSE, then bSL, then b.

When

b is displayed, wait 5 seconds and then initiate the software upload from

the uploader. Wait.

5 When the upload is successfully completed, the fixture displays the new version

number and resets. Disconnect the upload device.

To install software, backup method II

Use this procedure to install software only if all else fails.

1 Disconnect the fixture from the data

link and power.

2 Use tweezers to move the jumper on

the main circuit board to the boot

setting.

3 Prepare the MP-2 uploader for a boot

mode upload but do not initiate the

upload.

4 Connect the MP-2 uploader to the fixture as you would a controller. Terminate

the link.

5 Apply power to the fixture and wait 5 seconds. Initiate the software upload from

the uploader. Wait.

6 When the upload is successfully completed, the fixture displays the new version

number and resets. Disconnect the MP-2 upload device. Disconnect the fixture

from power and move the jumper back to the normal setting.

REPLACING FUSES

Warning! Never replace fuses with ones of a different rating!

To replace the main fuse

1 Unplug the mains cable from the input socket. Pry open the fuse holder and

remove the fuse.

2 Replace the fuse with one of the same type. The fuse rating is listed on serial

number label and in the specifications.

boot settingnormal setting

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 50 51

Sin comentarios

Martin MiniMAC Maestro Manual de usuario Pagina 44